(1) the right side of the rack transport sleeve put into suspension within the right frame, mounted on retainer locking. (2) the delivery of the left rack hanger and left panels together, the left wall hanger and left together, and then install the retainer and tighten the locking screw top. (3) on the belt, tensioner spring to hang the belt tensioner. 2. Bundled cord to adjust the number of stitches around: (1) the length and number of turns bale forage: see Table 1. (2) the length of the table according to pasture, the decision about the number of coils: see Schedule 2. As shown in Figure 6. (3) Note: A, the motor must be connected to the ground wire to prevent leakage machine. B, the main drive chain must once every 20 minutes plus oil, other rotating parts can be added to a class lubricants. C, about 20 per dozen bundles stop the machine, clean up the lower part of the operation of the machine and all parts of silt material, then boot to continue working. D, straw bale weight in moisture content is 55% to 65%, to 58 kg - 65 kg per bale is appropriate, is strictly prohibited more than 80 kg. Otherwise, long-term overload serious damage to the machine. E, the machine every eight hours after the operation, you must check all parts of the screws are loose, if any, must be tightened well. F ﹑ the chains should be checked regularly if it is too loose, loose wheel should tighten the tension. Chain pitch badly worn or stretched chain should be replaced. G ﹑ if boring car phenomenon, the operator immediately pulled the clutch lever, then release, then flip, and then release. At this point if the machine up and running, you can immediately roping. If the machine is not up and running, you must immediately opening a bundle. H, the winding roll, if the next part of the material, care must be taken when cutting blade on the tool holder needs to be cleared, or easily scratched hands. When the rope wrapped around without entering into a bale feeder pickup can be hand pulled the rope tight upper and lower rope automatically disconnected. Then re-roping. Must be strictly checked and replaced with a new chain I, chain after abnormal noise. Seven, safe use and precautions: 1. Before using the machine, please read the product manual, in the understanding of this machine is used and precautions, before using the machine. 2. The operator must have a warning label on the product, fuel, and other considerations such as the symbol of the nameplate after a clear understanding, as required to operate the machine. 3. The car should be preceded by checking whether all parts of solid and reliable, add a little oil before driving. 4. It should also be manually before driving the disk drive 3 to 5 weeks, confirming that no abnormal before they can start driving. 5. Start before driving, the clutch lever should be pulled, check the direction of rotation meets the requirements. Do reverse driving. 6. Before each job, you should empty running 2 to 3 minutes, make sure the machine smooth rotation, no other abnormal can only load test. 7. Load test 3-5 bundles, it should stop and check whether all rotating parts and fixed parts of other abnormal; if no anomalies can be put into production use. 8. If you use this machine motor for power, ground wire should be installed in the ground marking machines. 9. Do not drink and operate the machine. 10. The machine should be properly maintained to produce 2,000 bales. Car used again, based upon: 3,4,5,6,