Baler Instructions 1. Improper temperature control knob. In the top of the baler electrical control box, circuit board, open the control box cover, you can clearly see an adjustment knob clockwise increases the temperature adjustment, on the contrary decreased. Temperature is too high or too low, the adhesive effect is not good, so one should not adjust too much, the general tone between 4-5 ticks can be. 2. The power supply voltage is not normal. The machine should use 220V voltage. Many factories voltage often inadequate, if we use a long cable will cause a voltage drop so that the soup temperature becomes low, even when the motor burned tied tight. 3. The failure of electric tension spring strange hands. Electric strange long extension spring fatigue hands. So can not be packaged hot head to the upper and lower layers leads to adhesion between the belt half, or even less. 4. balers hot head position improperly adjusted. Hot head too low or the left, right, collide with packing tape or tool can not be packaged on two floors with a heated, should be adjusted according to the situation. 5. knife bearing rupture. Knife bearing rupture, so can not be on the top, so that the adhesive packing tape compression. 6. The internal temperature is too high. Smoke micro fan fails, the temperature is too high makes balers. 7. Hot head hotline fault tolerance. Check the resistance is broken burn hotline, such as loosening the nut should be tightened. 8. balers tied too tight power tune. Appropriate adjustments tied tight power.